|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
300 ohm, #18, 19 strand copper clad steel ladder line, PE jacket
|
Break Strength 2150 Lbs. Double braided, polyester (AKA Dacron). UV, mildew, rot and stretch resistant low coefficient of friction & high resistance to abrasion.
|
RF-9913, 50 ohms, PVC-I 0.405" Jacket, Air Dielectric spiral wrapped PE, #9.5 Conductor, 88% braid plus 100% foil Shield, 84% Velocity of Propagation, and a Capacitance of 24.0 pf/ft.
|
This LMR-195 UF coax cable can be used in almost any application where handling characteristics, improved shield and low loss is required.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Break Strength 2150 Lbs. Double braided, polyester (AKA Dacron). UV, mildew, rot and stretch resistant low coefficient of friction & high resistance to abrasion.
|
(2) Pack Amphenol PL-259 Connector Kit. Included are (4) 2 in. Pieces of our 1/2" Adhesive Heat Shrink Tubing (3:1 Shrink ratio) at no additional cost. Cable Type: RG-8, RG-10, RG-213, RG-225 - Shell: Brass plated with Nickel, Body: Brass plated with Silver. Contact pin: Silver plated.
|
The LMR-600UF 1/2 inch Ultra flex cable is super flexible due to its stranded center conductor. It has a tinned copper outer conductor that is taped and has a UV-resistant polyethylene jacket for outdoor use. 
|
Break Strength 2600 Lbs. Double braided, polyester (AKA Dacron). UV, mildew, rot and stretch resistant low coefficient of friction & high resistance to abrasion.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
150FT - RG-8U type, 13 AWG stranded (7x21) .085" bare copper conductor, polyethylene insulation, bare copper braid shield (95% coverage), PVC jacket.
|
RG-6 CATV-60, 75 ohm, solid BC, foam polyethylene (PE), foil w/ 60% AL braid coverge, black PVC jacket
|
Break Strength 2600 Lbs. Double braided, polyester (AKA Dacron). UV, mildew, rot and stretch resistant low coefficient of friction & high resistance to abrasion.
|
M17/111-RG303 Solid
silver-coated copper clad steel conductor with a polytetrafluoroethylene
(PTFE) dielectric, fluorinated ethylene propylene (FEP) jacket, and an
overall braid shield of 36 AWG silver-coated copper braid shield
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PVC-IIA C-17 Mil Spec Non-Contaminating .405" Jacket, PE Dielectric, #12 Stranded Conductor, 96% braid Shield, 66% Velocity of Propagation and a Capacitance of 30.8 pf/ft
|
Break Strength 770 Lbs. Double braided, polyester (AKA Dacron). UV, mildew, rot and stretch resistant low coefficient of friction & high resistance to abrasion.
|
14 AWG, 7 Strands - Bare Hard Drawn Copper Wire
|
Nickel (UHF) & Gold (SMA) Plated Brass Body, Nickel (UHF) & Gold
(SMA) Plated Brass Center Pin, Delrin (UHF) & PTFE (SMA)
Dielectric, “D/TN/GN/G”
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Davis RF - RG8X LL (low loss) 50 ohm, 16 AWG stranded BC, foam PE, foil shield, w/ TC braid black PVC (type IIA) jacket.
|
200FT - RG-8/U type, 11 AWG stranded (7x19) .108" bare copper conductor, foam polyethylene insulation, bare copper braid shield (95% coverage), PVC jacket.
|
Inner Conductor-Solid BC, Dielectric Foam- PE, Outer Conductor-Aluminum Tape, Overall Braid-Tinned Copper, Jacket- PE Black
|
RG 8/U - 50-57 OHM Coax - 13 AWG 7/21 Bare Copper; Gas Injected Foamed PE; Bare Copper Braid 97% Cov; Black PVC Jacket; .405" NOM OD; 82% Velocity
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#16 AWG; 19 strands Cu-clad with black poly jacket. Nominal OD .065 x
.930; Extra flexible & less likely to break in the wind. Nominal impedance 420(ohms); VP 91.7%. Good for -20oC to +60oC degrees.
|
14 AWG, 7 Strands - Bare Copper Clad Steel Wire:
|
RG-6 CATV-60, 75 ohm, solid BC, foam polyethylene (PE), foil w/ 60% AL braid coverge, black PVC jacket
|
14 AWG, 7 Strands - Bare Hard Drawn Copper Wire
|
|
|
