|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
RG-6 CATV-60, 75 ohm, solid BC, foam polyethylene (PE), foil w/ 60% AL braid coverge, black PVC jacket
|
RG-11 75 ohm, #14 solid conductor, 97% shield
|
#16 AWG; 19 strands Cu-clad with black poly jacket. Nominal OD .065 x .930; Extra flexible & less likely to break in the wind. Nominal impedance 420(ohms); VP 91.7%. Good for -20oC to +60oC degrees.
|
14 AWG, 7 Strands - Bare Hard Drawn Copper Wire
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
8-wire cable, two #18 and six #22 stranded copper wires, UV resistant, PE jacket
|
This LMR-195 UF coax cable can be used in almost any application where handling characteristics, improved shield and low loss is required.
|
PVC-IIA C-17 Mil Spec Non-Contaminating .405" Jacket, PE Dielectric, #12 Stranded Conductor, 96% braid Shield, 66% Velocity of Propagation and a Capacitance of 30.8 pf/ft
|
250 FT. 26 AWG, Black PE - Polyethylene Coat highly UV & abrasion resistant. Often referred to as "Kite Wire". Break Strength 25 lbs. 19 strands of copper clad Steel Wire. Weighs.38 lbs per 1000 FT.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The Andrew LDF4-50A 1/2 inch foam dielect 50 Ohm coax cable features a 5 inch bending radius that prevents kinking. This coaxial cable has an annular corrugated copper outer conductor and a copper-clad aluminum center conductor. Maximum frequency capacity is 8.8 GHz.
|
RF-9913, 50 ohms, PVC-I 0.405" Jacket, Air Dielectric spiral wrapped PE, #9.5 Conductor, 88% braid plus 100% foil Shield, 84% Velocity of Propagation, and a Capacitance of 24.0 pf/ft.
|
8-wire cable, two #14 and six #18 stranded tinned copper wires, UV resistant PE jacket
|
250FT - RG-8X type, 16 AWG stranded (19x29) .058" bare copper conductor, gas-injected FPE insulation, bare copper braid shield (95% coverage), PVC jacket.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Break Strength 2150 Lbs. Double braided, polyester (AKA Dacron). UV, mildew, rot and stretch resistant low coefficient of friction & high resistance to abrasion.
|
The LMR-600UF 1/2 inch Ultra flex cable is super flexible due to its stranded center conductor. It has a tinned copper outer conductor that is taped and has a UV-resistant polyethylene jacket for outdoor use.
|
Break Strength 770 Lbs. Double braided, polyester (AKA Dacron). UV, mildew, rot and stretch resistant low coefficient of friction & high resistance to abrasion.
|
The LMR-400 is a low loss braided coaxial cable. The 50 Ohm coax cable has a stranded outer conductor and a bare copper center conductor. It is 100 percent foil and 88 percent coverage braided shield prevents loss
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Break Strength 2600 Lbs. Double braided, polyester (AKA Dacron). UV, mildew, rot and stretch resistant low coefficient of friction & high resistance to abrasion.
|
3/4" Tinned Grounding Braid - 20 FT
|
#16 AWG; 19 strands Cu-clad with black poly jacket. Nominal OD .065 x .930; Extra flexible & less likely to break in the wind. Nominal impedance 420(ohms); VP 91.7%. Good for -20oC to +60oC degrees.
|
14 AWG, 7 Strands - Bare Copper Clad Steel Wire:
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Nickel (UHF) & Gold (SMA) Plated Brass Body, Nickel (UHF) & Gold
(SMA) Plated Brass Center Pin, Delrin (UHF) & PTFE (SMA)
Dielectric, “D/TN/GN/G”
|
RG-213: 13 AWG (7x.0296") Tinned Copper: Dielectric Layer .098" Solid Polyethylene: Shield Type, Tinned Copper Braid: Jacket, White PVC Type IIA (Non-contaminating)
|
UHF female / UHF female - 10" Bulkhead • Solid MACHINED BRASS body! • 16 point ends • Flawless nickel plating • Firmly secured DELRIN dielectric center for higher power handling ability • GOLD plated center pin • Excellent fit with large with large chassis nuts panel nuts.
|
(2) Pack Amphenol PL-259 Connector Kit. Included are (4) 2 in. Pieces of our 1/2" Adhesive Heat Shrink Tubing (3:1 Shrink ratio) at no additional cost. Cable Type: RG-8, RG-10, RG-213, RG-225 - Shell: Brass plated with Nickel, Body: Brass plated with Silver. Contact pin: Silver plated.
|
|