KV4YS Center Line Insulator
Original KV4YS center line insulator was developed and manufactured
by Dx Ham Radio Supply LLC. All stainless steel hardware
1/4" Center Eye Bolt and
3/16" eye screws including nuts and bolts. Conduit housing is
Schedule 40 for electrical use **UV protected ETL Listed and
conforms to UL 651 standard, Sunlight Resistant (will fade over
time)
** This is not Schedule 40
PVC conduit that is used for transmission of water.
Internal: We use Davis RF Flex Weave 14
AWG, 168 copper strand Wire for internal lead lines (
ultra-flexible aerial wire ...
FLEX-WEAVE
TM
is sometimes referred to as "wire
rope")
Connector; SO-239 "UHF" or "N" 4 hole panel mount silver plated
brass, with Teflon dielectric, (your choice at checkout). Inside:
SO-239 center lead is soldered to the Pin and the ground is
mechanically connected. Terminals inside are tinned copper.
Comes with 2" piece of 3/4", 3:1
Ratio
adhesive heat shrink to seal your coax
connector to the SO-239.